Are there any recalls on GE washing machines?
Are there any recalls on GE washing machines?
Remedy: Consumers should immediately unplug and stop using the recalled washers and contact GE Appliances for a free repair….Recall Details.
| Brand | Model | Serial Number |
|---|---|---|
| GE Profile | WPGT9350 WPGT9360 WPGT9150 | All serial numbers included |
Where is the drain pump on GE top load washer?
The drain pump is located inside the washing machine, near the bottom. To access the drain pump for this repair, you will need to remove the front panel.
How do you take the back off a GE washing machine?
Pull the washer away from the wall. Slide a putty knife between the top of the washer and the front panel about 3 inches from the left corner. Feel with the knife for a spring clip and press in on it with the putty knife to release it.
How do you stop a GE washer from loading?
To reset washing machines that use the GE Hydrowave system, start by unplugging the washer for one minute. Plug the washing machine back in and then within 30 seconds, quickly open and close the lid six times. You’ll need to do this within a 12-second period.
How do I know if my washing machine has been recalled?
Customers will need both the model number and the serial number of the appliance to check if their machine is affected. Both codes can be found either inside the door or on a label to the rear of the appliance.
How do I clean the filter on my GE top load washer?
These machines have rectangular-shaped lint filters in their wash baskets that need to be cleaned. Unclip the blue filters from the side of the wash basket by pushing down gently on the top of the filter. Open it, remove the lint and rinse in warm water. Close it and replace it by snapping the filter back into place.
How do you manually drain a GE top load washer?
Here’s how to do it.
- TURN OFF THE POWER. Unplug the washing machine from the power outlet.
- REMOVE LAUNDRY. Take out any clothing that’s in the washer tub.
- EMPTY THE TUB. Use a bucket to scoop the water out of the washer tub.
- MOVE WASHER AWAY FROM THE WALL.
- DISCONNECT DRAIN HOSE.
- PINPOINT THE ISSUE.
How do you fix a GE washer that won’t drain?
DRAIN HOSE To inspect the drain hose, turn off the power to the washer, disconnect the hose (have a bucket ready to catch any water), and check the hose for damage or obstructions. If the hose is clogged, take it outside and use a garden hose to clear out the blockage.
Why won’t my GE washer drain?
GE’s washer may have a clog in the hose, filter, or pump, which can cause the washing machine not to drain. Troubleshooting steps: To fix this, turn off the washer and unplug it from the power outlet. Then, remove any kinks in the hose and double-check that it’s connected to your GE washer properly.