How do you fix a dry code on a hot tub?

How do you fix a dry code on a hot tub?

The first thing you should do is check your tub’s water level. Top it off and see if this fixes the problem. Reset the tub GFI breaker to see if the error clears. If this simple fix doesn’t solve the problem, it may be time to check your hot tub filter.

How do I reset my hot tub?

How to Reset a Spa Heater

  1. Locate the spa’s high-limit reset. This is a red button found on many spa packs.
  2. Press the high-limit reset button.
  3. Turn on your spa and observe its operation.
  4. Flip the breaker panel switch on or press the reset button on the GFCI outlet to restore power.

What does dry heater mean?

Heater is Dry. Means there isn’t enough water to start it. Spa shuts down.

What does dry mean on Balboa hot tub?

There is a Verified “Dry” (drY or dY) Condition in the Heater. The “dr” or “HEATER MAY BE DRY WILL RETEST SHORTLY” Fault has occurred 3 times in a row without a successful Heating Cycle and Spa Functions are Disabled. There is Not enough Water in the Heater to Start it.

How do you get rid of an airlock in a hot tub?

There are two common ways to fix an air lock in your hot tub. The first method is very simple and involves turning your jets on and off until their function returns. Simply turn the jets on low for 10-20 seconds and then switch them to high for 10-20 seconds and repeat the cycle until the jets are working.

Why is my hot tub not getting hot?

Low flow in your spa or hot tub is most commonly associated with a dirty spa filter. If your spa heater won’t heat, remove and clean the filter(s) to rule out a pressure or flow rate problem. Low water level, a clogged pump impeller, closed valves, clogged pipes, or blocked spa drain covers can also cause flow issues.

Why is my hot tub flashing error?

The water probably isn’t flowing fast enough through the heater causing the temperature to increase. DO NOT USE THE HOT TUB while these error codes are flashing as the water will be scalding hot.

How do I reset my Balboa hot tub?

Remove the spa cover and allow water to cool. At 107¡F (approximately 41.7¡C), the spa should automatically reset. If spa does not reset, shut off the power to the spa.

How do you fix a dry error on a hot tub?

FLO, DR. or DRY errors commonly occur due to debris and blockages. They can usually be easily fixed with some simple hot tub troubleshooting steps, such as cleaning your filters and topping off your water level.

Why is my hot tub saying Dr or dry?

This error message is similar to the FLO error message. Like FLO issues, this can commonly be fixed by topping off your hot tub water level. DR or DRY will show up if there is little to no water travelling through your heater. There are a few simple things you can do to fix this problem.

Why does my hot tub keep saying my filter is dirty?

If the error clears, it was likely the fault of dirty filters. Clean your filters before putting them back in your tub to ensure the error message doesn’t pop up again. If your hot tub is still showing the message, it may be your circulation pump causing the problem. Check your circulation pump for any debris that may be clogging it.

Can a dry hot tub heater get too hot?

A dry hot tub heater can become dangerously hot and requires immediate investigation, warns Pool and Spa. Newer hot tubs have a digital display for error codes that can assist with troubleshooting.