How do I find my Honda ECU code?
How do I find my Honda ECU code?
The ECU can be located in several places:
- under a metal plate in the passenger’s footwell (88-91 Civics)
- in the passenger’s footwell behind the carpet (92-95 Civics)
- in the passenger’s footwell behind a plastic panel (96-00 Civics)
- by the driver’s footwell under a plastic panel (some 2001+ Civics)
How do I read obd1 trouble codes?
To get the check engine codes to flash in your dash panel, use a jumper wire or a paper clip and connect terminals A and B of the diagnostic connector. Turn your ignition key on with engine off and the codes should start to blink. All codes should start with code 12 which is one long flash followed by 2 short flashes.
How do I find my Honda Civic ECU number?
You can visually inspect your ecu’s part number on the ecu located on the drivers side of the engine bay near your intake. You may need to use a cell phone camera with zoom to be able to see the part number.
How do you check the codes on a 1991 Honda Accord?
You can retrieve your Honda Accord’s trouble code(s) yourself by using inserting a jumper wire at the diagnostic connector located in the passenger side kick panel. Insert the jumper wire in the 2 PIN service connector between pins 1 and 2. You should also see a 3 PIN connecter. This is used for a trouble code scanner.
How can I get my Honda code without a scanner?
Press the odometer’s Trip and Reset buttons while turning the ignition key ON. After turning the key ON, release the odometer Reset and Trip buttons to check if the Diagnostic Trouble Code or DTC appears on the odometer display.
How do I know what engine is in my Honda Civic?
Engine numbers can be viewed with the VIN number. Find the VIN number under the lower left corner of the driver’s side of the vehicle. You can find the engine size based on VINs under the same vehicle identification number.
Where is the ECU part number?
The Manufacturer Identifier and ECU Part Number are either stamped into the plastic case of the ECU or on a sticker on the ECU. The Bin File Serial Number is not visible externally, it is in the bin file inside the ECU.
How many CC is a 1999 Honda Civic VTi?
Found in: 1996–1999 Honda Civic VTi EK3 and Ferio Vi Displacement: 1,493 cc (91. 1 cu in) Piston Code: P2J Bore and Stroke: 75 mm × 84. 5 mm (2. 95 in × 3. 33 in) Rod Length: 137 mm Rod/Stroke: 1. 62 Compression: 9. 6:1 Power: 128 hp (95. 4 kW, 130 ps) at 7,000 rpm Torque: 102 lb·ft (14.
What kind of engine does a 1990 Honda Civic 25xxt have?
1990 Honda Civic 25XXT Formula (Japanese Market) VTEC 12-valve to 16-valve switch over : 3,000 rpm (below such engine speed, the engine is operating in 12-valve mode) Valvetrain : SOHC VTEC-E (USDM- Lean Burn Federal Emissions 49 State) (3-4 valves per cylinder depending on engine speed)
How many valves does a 12 valve Honda Civic have?
VTEC 12-valve to 16-valve switch over : 3,000 rpm (below such engine speed, the engine is operating in 12-valve mode) Valvetrain : SOHC VTEC-E (USDM- Lean Burn Federal Emissions 49 State) (3-4 valves per cylinder depending on engine speed) 1996–2000 Honda Ballade/Civic in South Africa, Venezuela, and Trinidad & Tobago SOHC VTEC-E 3-stage VTEC