How do you change the transmission fluid on a Acura TSX?

How do you change the transmission fluid on a Acura TSX?

Raise the car from the front and the rear, then secure it with four jack stands to keep it leveled.

  1. Figure 1. Raise and secure your car. Step 2 – Drain the transmission.
  2. Figure 2. Transmission drain plug location. Step 3 – Fill transmission with fluid.
  3. Figure 3. Fill transmission through dipstick. Related Discussions.

How much transmission fluid does an Acura TSX take?

A Acura TSX transmission flush also uses about 10 quarts of fluid to completely clean and flush out the system.

How often should you change transmission fluid Acura TSX?

If you regularly drive your vehicle under these conditions, have the transmission fluid changed at 60,000 miles (100,000 km), then every 30,000 miles (48,000 km). (For A/T only.) Independent of the Maintenance Minder information, replace the brake fluid every 3 years.

How do you check the transmission fluid on a 2008 Acura TSX?

How Do You Check Transmission Fluid?

  1. Turn your Acura on. You’ll want your engine warmed up, so you can best check the levels.
  2. Locate the transmission fluid dipstick.
  3. Remove the dipstick and touch the fluid.
  4. Get a rag and wipe off the dipstick.
  5. Use a funnel to bring the level up to full.

How long does it take to drain the transmission fluid?

between 3 to 4 hours
It can take between 3 to 4 hours to flush out the old transmission fluid by vacuuming or using a simple siphoning system. Siphoning or vacuuming is repeated to remove all sticky dirt from the synchronizing gear and until the inside of the transmission is clean.

What kind of transmission fluid does Acura TSX use?

Dexron VI Automatic Transmission Fluid
FRAM Transmission Fluid – Full Synthetic Dexron VI Automatic Transmission Fluid: 1 Quart (Part No. F426)

How do you check the transmission fluid on a Acura TSX?

Simply follow these steps:

  1. Turn the engine on for a few minutes before proceeding, since the engine should be warmed up to properly check the level.
  2. Find the transmission fluid dipstick.
  3. Remove the dipstick and touch the fluid, moving it around between your thumb and forefinger.
  4. Use a rag to wipe off the dipstick.

How do you check transmission fluid on a TSX?